Dongfeng 162 protection attack truck - vehicle maintenance - check transmission

Inspection Method

Check Gearbox No oil and oil seepage.

Checking the connection bolt is not loose.

Check if Gearbox There is no nest or loose phenomenon on the top ventilation line.

Check that there is no abnormality in each shift.

Check the lubricating oil surface.

Lubricating oil replacement cycle

1. Lubricants must be replaced after all walks.

2. Each 5000km driver should check the height and leak of the surface of the lubricant oil, and add it at any time;

3. The lubricant should be replaced each time 25000km.

replace方法

When replacing, transmissive lubricants should be replaced in the hot car status.

1. When replacing, remove the oil barrel, release the oil in Gearbox;

2. Cleaning the oil drum (the magnets on the screw is attached to accumulate oil) and fill;

3. Add the new lubricant from the oil tank to the lower edge of the fuel hole.

1. Ventilation port 2. Meet and check 3. Put the oil

Check to add mosaic lubricants

1. Fill hole screws 2. Put the oil drift

Replacement cycle

After the change, the oil is changed by 5,000 kilometers or half a year.

Replace 15000km or once a year.

Inspection Method

Turn off the engine before checking, stop the vehicle on the flat road, pull up the parking brake. Take the refueling screw and gasket, see the height of the discharge oil, and the level should be 12.7 mm from the fuel port.

If the level is too low, the specified lubricant is required, and the screw and gasket are mounted when the lubricant reaches the bottom of the fuel bore, and tightening the torque of 47n · m. Mirror overflowing liquid.

alternative method

Take out the oil absorption stamping and discharge mandatory lubricants. After ventilation, tighten the oil screw with 47n · m torque, 3.3 liters ATF DEXRON III lubricant caused distortion.

Check the drive shaft

1. Check if the cross shaft of the drive shaft is damaged.

2. Check the drive shaft connection, the support device is not loose.

3. Provides horizontal axis, sliding strips, and intermediate support.

This article is transferred to: {[1] Occupational Vehicle Co., Ltd. - \\\"CSK162 Protective Car Usage Maintenance Manual \\\"