Dongfeng 162 protection type assault car - vehicle maintenance - battery

dailymaintain

It is not necessary to maintain maintenance of the maintenance of the battery and do not need to add water within the time limit.

Check that the battery status indicator is normal. If the indicator is displayed, see the nameplate on the battery cover, strictly disable the deletion indicator.

When the load voltage is lower than 10V, the open circuit voltage is less than 12.5V and needs a car.

Status Check the voltage measurement method.

Parking time for more than 3 months must perform regular inspections and should be implemented.

Battery \\\"+ \\\" \\"- \\\" terminals are connected to the vehicle positive and negative wiring cable, please correct it.

The vehicle has too long, and if the vehicle is activated, a battery is required to perform a battery.

The battery must not be tilted or inverted to prevent electrolyte leakage.

Note the following when using it, the battery can be in a good working state.

1) Clean and dry the battery. If a battery power cord or battery connector is found, the battery, power cord, and joints are removed with metal cleaning. After cleaning, turn back the cable;

2) The battery power cord should be fixed, otherwise the battery will lead to electricity.

long

When there is no vehicle for more than a month, it is recommended to disconnect the battery cable. The battery status should be checked during the parking and charge it as needed.

Battery charging method

The technical requirements for maintaining a full sealing lead acid battery are as follows:

1. The battery connection method is connected in series, and each cell voltage difference is selected.≤A 0.2V battery is a group.

2. Constant current charging Each DC charging device can be connected in series, and the maximum output voltage of the apparatus is removed from 18.

3. Battery charge charging at 7A current is 16 ± 0.2 V, and the charge current is changed to 3.5A. On average, each battery voltage reached 16 ± 0.2 V and then continued to charge for 1 to 3 hours.

4. fast charging

4.1 Fast costs are limited to emergency measures that are temporarily unable to start, while others are implemented based on maintenance requirements and allow for charges to be specified in accordance with the specified.

4.2 Fast charging The first pressure is 16V and then charges 1 to 2 hours without more than 20A.

4.3 If the battery temperature during charging is high (hot hand), the charging should be stopped or the corresponding cooling should be taken.

Battery maintenance instructions

1. The battery should not be over-discharge during use, and the battery should be charged when the battery load indicator is displayed black.

2. The vehicle should not shrink or disconnect the battery negative connection. When the battery is deactivated, the battery is checked, and the voltage is low when the voltage is low.

3. Prohibit the use of battery terminal short circuit to detect whether the battery is electricity.

4. Wiring components are rugged, the end surface is cleaned, ensuring good contact with the battery contact.

5. The battery exhaust hole cannot be blocked, and the winter should be sealed in winter, otherwise it will increase the internal pressure of the battery, and the housing emergency will happen.

6. Strictly prohibit the conductive material near the metal tool and the terminal near the terminal to connect the metal material to the poles to cause short-circuit fires, combustion batteries and terminals.

Notice

1. Electrolyne solution in the battery to metallic, cotton products, stone, soil, and pay attention to the strong corrosion effect of proper use.

As shown in FIG. 2, the battery is used, and hydrogen is generated during charging, and an explosion occurs when the fire is met. It should be noted that the battery should be kept in a ventilation; for maintenance of the battery, smoking should be strictly prohibited. It strictly prohibits smoking; battery cars should allow for 10 minutes; often check and clean the battery exhaust holes to keep the battery exhaust hole smooth.

3. Pay attention to safety during processing to avoid hurt people or damage the battery.

This article is transferred to: {[1] Occupational Vehicle Co., Ltd. - \\\"CSK162 Protective Car Usage Maintenance Manual \\\"