Views: 0 Author: Site Editor Publish Time: 2021-07-16 Origin: Site
Check power steering oil
The power steering hydraulic tank is located below the engine cover.
Before checking the oil plane, the engine shuts down and wiped the tank. Unscrew the thin cover, wipe the scale on the gas cover, reload the oil method, then remove the oil standard, observe the height of the oil plane.
If the engine is hot, the oil should be between two tags. Otherwise, the power steering liquid should be added.
Check cycle: 5000km or month each time.
Replace when steering hydraulic oil changes or odor changes. Normal hydraulic oil is a clear and clear pink oil.
Replace power steering oil method
Insert the rear wheel of the car into the triangular pad, set the transmission, the front axle and the jack, so that both sides tyre are close to the ground.
Remove the turning port and discharge all oils of the steering system from the pipe. At the same time, start the engine and turn the steering wheel.
Confirm that the system oil is discharged, open the storage cover and replace the hydraulic oil filter.
After replacing the filter element, first filled the fuel tank, then start the engine, allow the engine idle, then add hydraulic oil. In this way, repeating several times, hydraulic oil is added to the downward slide of the oil rib.
notes:
It is forbidden to fill the hydraulic oil during operation.
The engine air rotation operation, the steering wheel returns to the steering wheel, which is conducive to the air discharge in the system.
When checking the oil plane, the engine must be turned off.
Sveral disk free rotation quantity check
When performing 20,000 km maintenance, the free rotation of the steering wheel should be checked, the free rotation amount on the left or right side of the intermediate position cannot exceed 15 °.
This article is transferred to: {[1] Occupational Vehicle Co., Ltd. - \\\"CSK162 Protective Car Usage Maintenance Manual \\\"
