Views: 269 Author: Lore Publish Time: 2024-09-18 Origin: Site
Sprinkler operation functions are: rear (left/right) high gun sprinkler, front hedge (left/right) rinse, rear sprinkler Tuo (left/right) sprinkler, spraying dust (optional), front duckbill (left/right) sprinkler (optional), rear hedge (left/right) rinse (optional), rear side spray (left/right) sprinkler (optional), top (left/right) green sprinkler (optional).
1. Start the chassis engine, press the power switch on the control panel and start the vehicle normally;
2. Depress the clutch after starting the vehicle, lift the power take-off switch and start the vehicle normally.
3. According to the operational requirements, open the “left rear hedge”, “right rear hedge” and other operational knob switch and then raise the engine speed to 1450r/min, start operations;
4. When you need rear sprinkler, rear side spray, tail bench water cannon, sprayer operation, you need to open the corresponding manual ball valve, and then raise the engine speed to 1450r/min, start the operation;
5. At the end of the operation, reduce the engine speed to idle state, close the knob switch and manual ball valve of the relevant sprinkling operation. Depress the clutch, press the extractor switch, cut off the water pump power, stop the operation;
6. After stopping the operation, check whether the extractor switch is closed and whether the valves are closed.
Note:
1. After starting the water pump, it is prohibited to raise the engine speed to more than 1500r/min under the state of each valve being closed. To avoid damage to the water pump;
2. After starting the water pump, it is prohibited to open or close the valves when the engine speed is more than 1450r/min to avoid damaging the water circuit;
3. After starting the water pump, it is prohibited to keep the engine speed above 1500r/min for a long time to avoid damaging the water pump;
4. Recommended operating speed is 20km/h.