Views: 11 Author: Site Editor Publish Time: 2021-08-05 Origin: Site
Off-road driving method
Since the vehicle is dangerous during off-road driving, the car must check the car and use the correct driving method before performing off-road driving to ensure safety.
Ramp
The slope of the slope is estimated to see the slope of the slope and determine the driving route.
The car load should be invisible, engage the front bridge, and the mandatory is hung into the low gear.
Mounting the transmission starts, there is no loose throttle and parking in the middle, keeping a constant engine speed on the hillside until the top of the slope; when the top is close to the top, the accelerator pedal is appropriately relaxed.
The slope is required to estimate the slope of the slope, check the road | and determine the driving route.
When the downhill, the engine must not be turned off, and it is not allowed to be braked.
When the downhill, the engine exhaust brake and the foot of the vehicle are effectively utilized, and the speed of the vehicle is maintained within a safe controlled range.
When hanging low speed or downhill, the highest speed of the engine does not allow more than 3,000 r / min. The engine is superchun, which is easy to make some components in the stressed state mechanical failure.
Before the steep slopes or untimely slopes, you must first try the brakes to work properly;
When the downhill is slowed down or when the transmission high speed is changed to a low speed, the speedometer must be viewed to verify the vehicle speed and detect the engine speed using the engine speed table.
Warning:
1. Max.gradeability of the EQ2102, EQ2102G series car is 60% (about 30 °). Loose or slippery road will reduce the climbing capacity of the car.
2. Turning on steep slopes is very dangerous and may lead to serious accidents.
3. The line straight downhill or downhill is relatively safe.
Water driving
Watch the depth of the water and the bottom of the water should be observed before the water is involved. Air filter must be avoided, and the exhaust tube should expose the surface.
The front bridge is joined and the mandatory is hung into the low gear.
According to the water depth or water width, the mount transmission is lowered.
4. The brake performance will affect the braking performance in the brakes of the car involved, should step on a few feet brakes while driving.
The moisture evaporates to ensure that the brake can work properly.
Warning:
EQ2102, EQ2102G series of car MAX. fording depth is 1 meter.
The engine must be prevented from intake, otherwise the engine will result in severe damage.
The vehicle must be low-speed and keep the vehicle speed evenly.
After the water is involved, you must check the working performance of the brake and make it possible to work.
Swamp area
Before entering the swamp, you must first identify the swamp and cannot be blindly entered.
The pressure of tyre is reduced to 250 to 300 kPa.
The front axle is hung in front of the swamp to the low grade.
The transmission is hung in low-grade, moving across the swamp, and if the speed of the car, it may cause the vehicle to be trapped.
Trench
The width of the trench must be identified across the trench.
The front bridge is joined and the mandatory is hung into the low bar.
The transmission is slow and steadily through the trenches, avoiding damage to the front bridge and the steering system due to the impact.
EQ2102, EQ2102G series car can climb the bottom of the bottom of 6,000mm, high 1,300mm
Flush
EQ2102, EQ2102G series cars can pass deep 2,060mm, a pit having a diameter of 14,000 mm.
The size, soil and slope of the pit must be identified before the popping slit.
The front bridge is joined and the mandatory is hung into the low gear.
The transmission hangs slowly through the slit, and there should be someone command next to the vehicle load to ensure full.
This article is reproduced from: Dongfeng Motor Company - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"
