Views: 1 Author: Site Editor Publish Time: 2021-07-31 Origin: Site
Park brake manipulation handle
EQ2102 series model parking brakes on Middle Axle/ Rear Axle wheel. Its manipulation is controlled by the handle valve manipulator on the right side of the driver. When parking, pifton the handle to the brake position. When the vehicle starts, you need to pull up the locking sleeve of the handle and pull the handle forward to relieve the parking brake.
1, release brake 2, brake position 3, pull up
Parking brake emergency release method
When the pressure of the spring brake gas chamber is lowered, the spring brake is automatically actuated, first check the pipeline system or valve, there is no air leakage, and should be repaired in time. When the parking brake is needed in an emergency, the following method can be used.
Method 1: In the case of normal air supply failure of the brake system, when the vehicle cannot start, in an emergency, the spring brake air chamber inflatable switch is rotated, and the spring is braked, so that the vehicle Can start walking.
The specific method is: use a wrench or pliers to rotate the spring to the air chamber air chamber to rotate 90 °, and the parking brake can be released by the vertical position to the horizontal position.
1, spring brake air chamber inflatable switch 2, normal state 3, emergency relief brake state
Warning:
1. Spring brake air chamber inflatable switch is limited to an emergency, in the case of relocating parking brake, the vehicle has no car.
2. Afterwards, the lack of lack of braking air pressure must be excluded, and the spring brake air chamber is required to return to the normal position after the failure is eliminated.
Method 2: Turn the spring to remove the bolt with a wrench, until it is unlimited, and the W brake can be released.
1, spring brake release bolts
Warning:
Afterwards, you must find the reason for the lack of braking air pressure, and repair it in time. After troubleshooting, you must install the bolt to restore the parking brake function.
Method 3: Open the hanging car brake separation under the front bumper of the cab, turn on the external gas source.
Warning:
1. Remove the parking brake is limited to an emergency, and it is dangerous to use the vehicle without parking brake, which is likely to cause injury accidents.
2. The reason why the spring brake air pressure must be found afterwards, and it is repaired in time. After troubleshooting, you must install bolts or make the spring brake air chamber inflatable switch back to the normal parking brake function.
This article is reproduced from: Dongfeng Automotive -\"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"
