Views: 20 Author: Site Editor Publish Time: 2021-07-30 Origin: Site
switch
When the switch is pressed up, turn on the full vehicle power supply, and press the switch down to disconnect the full vehicle power. The power should be disconnected when maintenance and maintenance of the vehicle circuit system to protect other electrical equipment.
1. Disconnect the power supply 2, the power is turned on
Note:
1. When the engine is running, it is strictly forbidden to turn off the power switch.
2. When departure, you must turn off the power switch.
Fog light switch
When driving in a dense fog, press the switch, the front fog lamp is lit.
Gas, electric horn conversion switch
The vehicle operates the switch on the way, and you can choose to use the electric horn or the air horn.
Dangerous alarm light switch
When the dangerous alarm light switch is turned on, the forward and right turn signal lights are light and flashed, reminding other vehicle pedestrians.
1. Danger alarm light is on 2, close 3, parking lights
Lord, vice tank oil display conversion switch
The main and the vice tank oil is indicated by the fuel gauge, and the fuel gauge can be displayed in the main and sub-tanks by the conversion switch. See page 24 for main via tubes.
Note:
First use the fuel in the main tank and then use the fuel of the via tank. Otherwise the fuel will overflow from the main tank.
Long-distance control switch
The switch is used to control the manipulation of the splitter, the front bridge, the strobe, etc., i.e., after the switch is pressed, the remote manipulation of the splitter, front bridge, and stroke, etc. can be realized. See the manipulation and use of the striper, striper and front bridge on page 45.
This article is reproduced from: Dongfeng Motor Corporation -Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual