Views: 5 Author: Site Editor Publish Time: 2021-08-11 Origin: Site
Front bridge steering festival and three-sell universal joint
When maintenance, the primary pin bearing and three-pin bearing is added to the contact grease and inspect the fastening of the steering throttle tension bolt and the cross rod arm. When the three-pin bearing is incorporated, the wheel should be joined, loosen the bolts on the bearing cover so as to take the air, tighten after the injection, so as not to interfere with the steering.
Steering seater adjustment adjustment
Adjusting should be carried out when the wheel is landed. After tightening the main pin auxiliary cover, tighten the main pin stop screw in the torque of 10 to 20N.m, so that the steel ball is pre-tightened between the steel ball and the ball bowl, then tightening the bearing nut with a torque of 98n.m. . After adjusting, the road test should be carried out, do not produce obvious swing when the vehicle is driving, and the steering is not heavy.
1, steering sedent shell
2, steering limit bolt
3, thrust bolt
4, upper bearing cover
5, tension bolt
6, inner half-axis grease mouth
7, steering festival
8, horizontal tilt rod arm
9, lower bearings
Adjustment of the end face gap of the steering throttle and the lower bearing bearing oil cover
This gap is 1 ~ 2mm, and check when it is discovered to a heavy or a card. When the front wheel is landed, the gap is checked with a thick rule, and it should be adjusted when less than 0.2mm, and the lower bearing cover is removed, and the lower pad of the lower pad is 1mm thick.
This article is reproduced from: Dongfeng Automotive - \"Dongfeng EQ2102 / EQ2102G Series Off-road Motor User Manual\"
