Views: 5 Author: Site Editor Publish Time: 2021-07-28 Origin: Site
dash board
1, oil pressure gauge (see page 5) 2, fuel gauge (see page 6) 3, water temperature meter (see page 6) 4, engine speed meter (see page 6) 5, speed mileage list (see No. 7 pages) 6, brake gas stamps and voltmeter (see page 7) 7, control while board and air outlet (see page 25) 8, steeid switch (see page 11) 9, alarm and indicator (see 8 pages)
Oil pressure gauge
The oil pressure gauge indicates the oil pressure of the engine lubrication system. When the lubricating oil temperature is relatively low, the oil pressure of the oil pressure gauge is high in the hydraulic pressure of the normal temperature. The normal range is between 2 to 3.
Fuel gauge
The fuel gauge is used to indicate how much fuel tank storage oil. When the key switch is in the ON position, the table works. Dictionary on the mark f
Indicates that the fuel tank is filled, and E indicates that the oil of the fuel tank is exhausted. When the indication is close to E, it should be added as soon as possible to add the cleaning fuel.
Water temperature meter
The table is used to indicate the temperature of the engine coolant. When the key switch is located on the ON position, the table works. The mark c on the scale disk represents a low temperature, H represents a high temperature. The ideal temperature is between the two engraved lines in the middle.
Engine speedometer
The pointer to the speedometer indicates the number of revolutions per minute. The engine prohibits the speed in the red region (2) in any case, and the driving vehicle will save fuel and extend the life of the engine in the green area (1).
Green area 2. Red area
Vehicle speed mileage
The speedometer includes a speedometer (in km / h) and a mileage (in km).
The pointer of the speedometer indicates the vehicle travel speed. The total miles show your vehicle has running the total number of mileage, don't forget to maintain your vehicle according to the mileage.
Short-range miles facilitate your distance of a certain driving. Press the reset button and the value displayed returns to zero.
1. Total mileage table 2. Short distance mileage 3. Reset button
Note:
The vehicle is strictly forbidden to manipulate the reset button during the driving process.
Voltmeter
The voltmeter indicates the end voltage of the battery when the engine is stopped. After the engine is started, the charge voltage of the generator is indicated, and the voltage value is higher than 24V.
barometer
When the pointer is within the red area, the vehicle is prohibited from starting to start. After the air pressure exceeds 450 kPa, it can start.
1, front brake system air pressure table 2, post-braking system pressure gauge
Warning:
The brake system air pressure must be greater than 450 kPa when starting.
This article is reproduced from: Dongfeng Automotive - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"