Views: 1 Author: Site Editor Publish Time: 2021-08-10 Origin: Site
Replace the oil inspection
inspection cycle
Row 4,000km.
Inspection Method
Unscrew the fuel and oil surface check the hole sealing screw, the height of the oil surface is accurate, and it is not enough. At the same time, you should also check the condition of the air plug and clean it.
1. Cooking and oil surface detection holes 2. Pitting oil
Replacement cycle
Maintenance per 24,000 km
alternative method
Transmission lubricants should be replaced in a hot car state. When replacing, the oil dried screw is discharged, and the oil in the transmitter is discharged, and the oil (the magnets on the screw adsorbed the oil-adsorbed toner), fuel and oil surface inspection holes to add new lubricants.
Notice
The oil surface is too low, such as storage bearing and gear, which will cause overheating and oil.
The ventilation headphones should always be maintained.
Check and replace the discharge oil
inspection cycle
8,000km.
Replacement cycle
24,000km.
Drive n bridge lubricating oil surface
inspection cycle
8,000km.
Replacement cycle
24,000km.
Inspection Method
Unscrew the oil surface inspection hole screw, the height of the oil surface is subject to the lower edge of the hole and is not enough. At the same time, check the condition of the air plug and clean it.
1. Risk screw 2, fuel port screw 3, oil surface inspection hole screw 4, suctioner
notes:
1. When refueling, don't let dust or dirt enter the lead.
2. The surface of the oil will be used in normal height, too high or too low. 3. The ventilation headset should always be maintained.
