You are here: Home page » news » Vehicle knowledge » Dongfeng EQ2102 Series User Manual - Maintenance and Adjustment - Checking and Adding Coolant

Dongfeng EQ2102 Series User Manual - Maintenance and Adjustment - Checking and Adding Coolant

Views: 3     Author: Site Editor     Publish Time: 2021-08-05      Origin: Site

Check and add coolant

1. In order to examine the liquid plane of the coolant, the ignition key can be screwed to the on position, check whether the liquid surface alarm lamp of the coolant is lit, if the buzzer has word, then a coolant is required. It is also possible to use directly from the expansion box to observe. If you see the water, you have to add it.

2. Fill the coolant from the rear of the cab until the coolant page reaches 4/5 of the expansion tank height.

3. Check the working conditions of the sealing box to add a stress cap

056423407

Notice:
1. Before adding the coolant, you must check if the engine cartridge radiator leaks. If you fix the first one
2. It is recommended that coolant uses Dongfeng The best-selling antifreeze anti-rust coolant produced by the automobile company, which is strictly prohibited from using tap water or well, river hard water.


Radiator drainage
The switch shown in the figure below opens the cooling solution in the cooling system.
0508


Replace engine lubricating oil

Replacement cycle
This is the first time, the new model is 1500 kilometers
Future replacement: 8000km

Check engine lubricating oil plane
1. For about 5 minutes after the engine is closed, pull the oil out and wipe it quickly, then reload the ruler.
2. Turn the oil mark again and observe the height of the oil plane. When there is no longer two engraving lines, you need to add a cleaning lubricant. Excessive also removed from the oil absorbing screw. The rails of the fuel tube indicate that the existing capacity is 14.3L, and the bottom line indicates 12.4L.

00688


Replace engine lubricating oil

0658Oil shell 2. Put oil

  1. Put the oil oil ink into the bottom of the oil bottom, place the lubricant into the tank

  2. Re-decorative oil drill

  3. Replace the oil filter, clean the filter sealing joint surface

  4. Add new lubricants to standardize

  5. Start the engine, observe the filter and suction bin in the case of idle speed. After 5 to 10 minutes, the stop waiting to verify the oil level of the engine lubricant until the lubrication level is a normal range.



00548

  1. Fold


This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"

Hubei Off-Road Special Vehicle Co., Ltd.
Address: No. 6, Huimin Road, Maojian District, Shiyan City, Hubei Province, China
Tel: 86-719-8888190 Tel: 86-18986895008 / 86-18986890909 Email:fanya_trade@163.com
Copyright © 2021 Hubei Off-road Special Vehicle Co., Ltd. Record certificate number:Hubei ICP No. 20010516-3