Dongfeng EQ2102 Series Vietnam Motor Manual - Maintenance and Adjustment - Adjustment of Wheel Brake Brake Delum

Wheel brake brake gap regulation

Front wheel braking brake gap regulation

After a certain mileage of the vehicle, the brake gap is increased by the wear of the friction plate and the brake drum, and when the brake gap is increased to a certain extent (ie, the push rod stroke of the brake gap is greater than the adjustment brake gap, 1 mm or The brake room is greater than 40mm. Wipe the soil oil in the arm of the arm, then use the wrench to block the locking sleeve on the hexagon of the worm, so that the worm shaft is in a non-locked state, climbed clockworm shaft, and the braking gap is lowered. The hourly needle mobilizes the worm shaft increases. When the worm is blank, the needle should be tightened, and the needle should be easily retracted from 1/2 to 2/3 3. At this time, the brake drum should be free to rotate and will not rub any part.

notes:

After adjustment, be sure to lock the locking sleeve and lock the hex head of the worm shaft.

Medium-rear wheel braking brake gap regulation

Normal examination: 8,000 kilometers per car; inspection, adjust the brake clearance: 0.7mm.

Adjustment method:

1. The lock sleeve is pressed by the plum wrench, the locking sleeve is pressed, and the worm shaft is pressed, so that the friction plate is in contact with the brake drum, and then the reverse rotation of azol shaft 1/2 ring. At this time, the brake drum should be free to rotate and there is no partial friction.

2. Checking the brake gas chamber stroke should be 35mm.

notes:

1. Strictly prohibit the use of cutting moving air chamber pushers to change the push rod stroke.

2. When adjusting the brake, be sure to park your car in a flat place and ensure that the gas pressure is 700kPa.

This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"