Views: 3 Author: Site Editor Publish Time: 2021-08-11 Origin: Site
Front bridge steering festival and three-sell general joint
When maintenance, the primary pin bearing and three-pin bearing are connected to the grease and inspect the fastening of the steering throttle tension bolt and the crossbar arm. When a grease is added to the three-needle bearing, the wheel should be connected, loosen the bolts on the bearing cover to peel, tighten after the injection, so that it does not interfere when steering.
Steering seating adjustment adjustment
When the wheel is landed, it should be adjusted. After tightening the main pin, tighten the torque of 10 to 20 N.m of 10 to 20 N.m, so that the steel ball is predicted between the steel ball and the ball bowl, and then tighten the bearing nut with 98N torque. M. . After adjustment, road testing should be conducted, there is no obvious swing at high speed, and the steering is not important.
1, turn to heavy shell
2, steering limit bolt
3, promote bolts
4, upper bearing cover
5, tension bolt
6, inner half-axis oil port
7, steering section
8, horizontal inclined pole arm
9, lower bearing
Adjusting the end gap and the lower main pin bearing oil in the steering feed housing
This gap is 1 ~ 2mm and is checked when discovered heavy or card. When the current wheel is ground, the thickness checks the gap, and should be adjusted at less than 0.2 mm, and the 11 mm thick spacer is removed under the lower bearing cover under lower pad under lower pad.
This article reprints from the following products: Dongfeng Automotive Company - \\\"Dongfeng EQ2102 / EQ2102G Series Vietnam Motor User Manual \\\"
