Dongfeng EQ2102 Series Vietnam Motor Manual - Startup and Driving - Clutch Operation

Clutch operation

When using a clutch, it must be completely separated; the clutch separation is not the main reason for damage the clutch. During the driving process, from the high-speed gear to the low speed file or from the high speed gear of the low speed to the high speed gear, the shift method of the two leg clutches. Do not put your feet on the clutch pedal after completing the clutch operation

1. Quickly press the pedal 2. Transfer the operating lever to air block 3. Fast release pedal 4. Quick press pedal 5. Shift 6. First fast clutch pedal to semi-engagement position, slowly relax the clutch pedal

Braking operation

To successfully stop the vehicle, the brake pedal should do the following:

1. Before the parking lot, parking 25 to 35 meters, shooting 1/2 ~ 1/3 under the brake pedal;

2. When the parking space is scheduled to be 5 ~ 6 meters, the pedal gradually relax;

3. Before going to the parking lot, gently stepping on the brake pedal and stop the car completely.

notes:

1. If the brake pedal is not placed, the car will stop in the influence of short distances.

2. Avoid dilapidated pedals because this can discharge air in the trachea, resulting in the loss of vehicles.

3. When braking parking, you should use a foot brake.

4. In addition to an emergency, it is not recommended to use emergency braking methods. In particular, in the case where rainwater is easy to slide, the use of emergency brakes may have conditions such as side slip.

5. Wash or through a deeper puddle, there can be water to enter the brake drum, so the braking effect can be reduced, and when the low speed is driven, the water is conducted, and the water is evaporated to ensure that the brake can operate normally.

Parking surgery

1. Try stopping in a flat place during the car.

2. The parking brake handle is switched to the brake position and seals the transmission, and the wheel is jammed with a triangular pad.

3. Do not shut down the fire immediately before parking, you must run 3 to 5 minutes in idle state, you can turn off the engine coolant temperature. Especially after the engine's large load or high speed, it must enter the idle speed, otherwise faults, such as engine pull-up and superchargers.

4. Close all switches after the flameout, especially the power switch.

go back

1. Winding, checking without oil spill and other exceptions.

2. Turn on the trachea to discharge water, exclude water.

3. Repair the fault found during the driving process.

This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"