Views: 1 Author: Site Editor Publish Time: 2021-08-09 Origin: Site
Check and replace power steering hydraulic oil
Wipe the oil tank to clean before checking the oil plane. Remove the oil tape assembly assembly, wipe the ruler, re-add the oil method, then remove the oil standard, observe the oil plane height. If the oil plane height is not at the bottom of the oil, the same type of hydraulic oil needs to be added.
inspection cycle
Every time you drive 4000 km
Replacement cycle
First driving 4000 km
Each driver 24000km.
alternative method
1. Place the car with a triangular pad, tape setting, front axle clamping jack, so that two sides tyre
2. Unscrew the steering and extract the pipe joints and discharge all oils of the steering system. At the same time, start the engine, turn and fly the steering wheel
3. Confirm that the system oil is discharged, open the storage cover, replace the hydraulic oil filter
After replacing the filter element, the fuel tank, the engine is excavated, the engine is running, the engine idles, and then adds hydraulic oil after the flame is cut off. In this way, repeating several times, hydraulic oil is added to the bottom of the oil rib.
Notice:
1. Prohibit the engine to fill hydraulic oil during operation
2. Engine idle operation is simultaneous and the steering wheel is rotated. It is conducive to air emissions in the system.
3. When checking the oil plane, the engine must be closed.
Sveral disk free rotation quantity check
Keeping 12,000 km maintenance, check the free rotation of the steering wheel, free rotation of the free rotation can be free to 15 ° free to 15 °.
This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"
