Views: 2 Author: Site Editor Publish Time: 2021-08-14 Origin: Site
Light adjustment method
General adjustment
The car parked on the dark and plane, turning the light switch to the lowlight, rotates the adjustment screw of the external headlight, and adjust the low light. After adjustment, turn the light switch in the remote control, block the adjusted headlight through the cardboard, then turn the inside auxiliary headlight adjustment screw, adjust the high beam light.
Standard adjustment method
Ready to work
The light adjustment site requires a flatness, and the screen and website used are vertical.
The vehicle is empty, take a driver, tyre The air pressure is normal.
The vehicle is perpendicular to the screen, allowing the headlight to turn the screen 10m.
Draw a horizontal basis on the screen, the height of the reference line is the same as the center of the headlight, and the height word is H, and the left and right headlights according to the front lamp position mark according to the vehicle of the vehicle. metallic line.
First adjust the low light, then adjust the highlight.
Low light
Light beam on the screen, need:
The height of the beam mirror or the midpoint is 0.6 hours to 0.8 hours. 2. The horizontal direction should not exceed 100 mm.
High beam
High beam lights on the screen, need:
The height of the beam center is 0.85H ~ 0.9h,
The horizontal position of the left high beam is not more than 100 meters to the left, and the right polarity cannot be greater than 170 mm.
The horizontal position of the right high beam at the horizontal position of the right high beam is not more than 170 mm.
Front fog lights
The front fog light illumination performance should be less than 2250 mm clear horizontal bright and deep lines in front of the front mist center. (The horizontal and vertical baseline determination methods on the screen are the same as the steps in the preparation.
This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"
