Views: 2 Author: Site Editor Publish Time: 2021-08-06 Origin: Site
Oil filter
Replacement cycle
8,000km.
alternative method
Use a dedicated filter wrench to remove a dedicated filter. When installing a new filter, remove the surface of the joint, the cleaning lubricant in the filter, and then filtered to the filter, the sealing surface is connected to the joint surface, and then tighten 3/4 turns. After the engine is started, the oil does not leak.
1. Oil filter 2. Filter wrench
Notice:
1. Do not use the filter wrench when installing. Otherwise, thread deformation and filter are damaged.
2. When loading a new filter, be careful not to match the model required for the model.
Fuel filter and oil separator
Replacement cycle
Fuel filter and oil separator: 12,000km per car
Fuel presuppracting: 24,000km per drive
alternative method
At the time of replacement, the fuel filter and fuel filter are taken out with a dedicated filter oil separator. When a new fuel filter and a fuel filter are installed with an oil-water separator, the joint surface is wiped, and the fuel filter and fuel filter filled with the oil water separator filled with cleaning fuel, and then uses hands. When the filter is connected to the engaged surface, 3/4 is tightened by hand.
1. Fuel filter 2. Fracture valve 3. Oil water separator
Fuel filter and oil water separator
Turn off the engine, open the discharge valve, discharge the water and precipitate. Tighten the leakage valve when cleaning fuel
Notice:
1. When installing, the oil water separator of the oil filter is not allowed, otherwise the thread deformed and damaged filters will be manufactured.
2. You can only use your hand to tighten the leakage valve, you can't use any tools
3. When you change water, you can't open all Ventur valves.
Fuel presuppractor
Water cycle
Every time you drive 4000 km
Replacement cycle
Each driver 24000km.
Alternative method of fuel filter and oil separator
This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"