Dongfeng EQ2102 Series Vietnam Motor User Manual - Startup and Driving - Preheating Start Operation

Intake preheatingStartoperate

It is provided to preheat the intake of intake of the engine at a low temperature environment (5 ° C to -41 ° C).

The procedure is as follows;

1. Closed intake preheating switch.

2. Pull out the pre-hot button, the intake preheating indicator lights up, and start preheating. When the intake is used, the air is pulled out and the pull button is pulled out to the appropriate position, and the intake of the vacuum cleaner will remain in this position.

1, hot door button 2, intake preheating switch

3. The preheating time is 6 minutes. After the preheating is completed, the intake preheating indicator flashes, the buzzer is called, and the engine can be activated.

4. After starting success, the preheating start switch has been closed, and the preheating damper button is reset, press the button first press the drop button, then press the start button.

If it is not successful, you can repeat the above steps.

The preheater is 3. 12 minutes. When the preheating time is completed, the preheater automatically cut off the engine without start or 12 minutes after the preheater begins. The buzzer stops torsion, indicating that the light turns constant brightness, indicating that the driver should turn off the preheater switch.

notes:

1. In the normal operation of the preheater, if the engine is unsuccessful, the engine start speed and fuel supply condition should be checked.

2. When using a preheater in a very low temperature environment, it is not necessary to prevent the throttle pedal to prevent the engine from rapidly rise after the start of the engine, causing oil supply systems from oil supply and causes flameout.

3. When the vehicle is not sufficient to charge every day, it should be carefully employed according to the battery capacity.

key point

When the vehicle is used in a cold environment of -41 to -30 ° C, you can refer to the following usage points:

1. Fuel is selected from -50 diesel.

2. Engine lubricant uses OW / 30 CD diesel, temporarily uses the 14th severe cold area thickened oil

3. Use long-range antifreege.

4. Use a low temperature battery and a battery insulation device.

5. Heating the cylinder and oil housing using cylinder coolant heater and oil heater.

The EQ2102 series model can optionally be a cooled coolant heater, an engine electrothermal heater and an engine preheat, as long as the AC power in the parking space can be.

When using a heater, the preheated harness (two) is inserted into the cylinder coolant heater and the electric heater, and the other is inserted into a 220V AC power outlet (see Figure H-A-061).

With engine cylinder coolant heater and oil heaters, the operating temperature is greater than -36 ° C for more than 10 hours, and the engine can start successfully.

1, electric heater 2, connect 220V AC power

This article is from: Dongfeng Automotive Company \\\"Dongfeng EQ2102 / 2102G series off-road vehicle manual \\\"