Views: 3 Author: Site Editor Publish Time: 2021-08-04 Origin: Site
Separator, producer and front bridge
When the car runs or does not operate or does not have a pavement in a bad way, such as sand, muddy, water can enter the front bridge and the rotator to improve the transmission performance of the vehicle.
Operating front bridge, manipulation of a reel and a stripper is controlled by electrical control. That is, remote manipulation is achieved by operating a solenoid valve in a solenoid valve.
When using the front axle, mandatory, the power board should first press the remote switch, otherwise it will not be used.
Three switches on the dashboard operate the rotator, the front bridge, the front bridge output shaft is positive, reversed. These three switches are self-locking. When operating, you must press the self-lock button to turn the switch handle.
1, button
Front bridge drive operation method
When the car drives when driving, the sand or steep slope is not easy to pass, the front bridge can be used to improve passing capabilities. When you need to hook the front bridge, step on the clutch when the throttle is turned on, then turn the front bridge to the switch handle to \\\"front bridge to pick up \\\", because the front bridge should be engaged, at this time The front bridge bonding indicator will also illuminate. When driving with a good way, the switch should turn to \\\"empty \\\" so that the front bridge driver is detached.
1, all power output (optional) 2, front bridge drive disconnected 3, front bridge driver
notes:
Using the front bridge driver under normal road will increase the fuel consumption and intensify tyre wear.
If the front bridge is not running within the joint cycle, gear injury is easily caused under sudden load conditions.
This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"