Views: 6 Author: Site Editor Publish Time: 2021-08-03 Origin: Site
Replace tyre
Delete tyre
1. Remove the front wheel (rear wheel), first use a triangular pad back wheel (front wheel).
2. Remove the wheel nut of the wheel nut in the car with wheel nuts.
3, one end with Axle of jack, turn the wheel.
4. Remove the wheel nut.
notes:
1. The wheel nut on the right side of the vehicle is the right line, the nut on the left is the left thread.
2, wipe the wheel bolt to expose the thread and apply a small amount of grease.
Install tyre
1. Use a bar to make the tyre edge bolts into the hub bolt.
2. Tighten the hub bolts to the center position of the bolt hole, tighten the tyre nut.
3, slowly put the jack until tyre is in contact with the ground.
4, the nut tighten the torque of 300 to 350n.m and tighten the nut to the specified torque three times. When the wheel is mounted on the hub, a first perspective is required to tighten the two nuts (as shown in the fastening order) II A-060). Note that when tightening, the spherical surface of the nut is correctly bonded to the spherical surface of the threaded hole on the rim, so that the rim is stopped, then tighten all nuts sequentially, otherwise the bolt is easily broken when driving.
Alternate tyre
1. Remove the two nuts mentioned in the arrow in the figure, the handle of the switch switch in Figures HA-005 to position A. Move the standby tyre to the ground with an appropriate force to use {[[ 17]} Rotate to the ground. .
2. When you need to put the standby tyre back to the frame, the switch handle should first in place B, then shake the oil pump handle, you can put the backup tyre back the frame.
3. Patch and tighten the nut reflected by the arrow.
notes:
When disassembling tyre, the cab must be in a locked state.
Alternate tyre should be more important and should pay attention to safety during improvement.
This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"