Dongfeng EQ2102 off-road vehicle Manual series - structure and operation - Cab tilt

Cab flipping

Preventive measures before opening the cab

1. Try to stop the vehicle on flat.

2. When the cab is tilted in the workshop or room, please pay attention to whether the front and upper space is sufficient.

3. Verify that the parking brake handle is in the locked position and place the shift lever in the neutral position. When needed, tyre will use a triangular pad.

4. Verify that some of the zero points in the cab is cleaned up and the items that are easy to fall during the flip process will be safe.

5. Confirm that the fetus is in a locked state.

EQ2102 flip operation

1. Unplug the buckle from the lock pin, then remove the lock pin, and put down the guard.

notes:

Before shirking a taxi, be sure to put your front guardrail, otherwise you will take the cab.optimal.

1, lock 2, buckle 3, front shroud

2. Unplug the pin from the tilt lock rod, completely pull the tip lock rod to the bracket.

1, row lock rod 2, lock pin 3, bracket

3. Remove the lock pin of the switching switch and pull the converted handle to position a. Insert the crowbar into the hose handle and drive oxygen will rise slowly. There is a groove on the lock plate, and the root requires a suitable sharp corner such that the lock is stopped into the groove to prevent the cab from itself from itself.

1, crowbar 2, oil pump handle 3, conversion switch handle 4, conversion switch lock pin

warn:

The locking block must fall into the groove, otherwise the cab may collapse to the accident and personal injury.

4. If you want to fall down the cab, you can fall back to the lowest position B, and then the oil pump I handle can slow down the cab. The switch switch is locked.

5. After the cab is completely placed, press the tip locking rod. Insert the lock pin in the hole of the tilt lock lever bracket.

2102G cab rowing operation

1, put down the front guardrail, run with EQ2102.

2, lock the pin from the tip lock.

3, when pulling out the safety lever, pull the tip lock lever completely pulled until it is set to the bracket, the cab can be completely ended. If you can't flush automatic, you can push it with your hand.

1, lock pin 2, inclined lock rod 3, safety rod 4, bracket

4. When the cab is turned into place, the tearing rod is straight, and the safety pin is inserted into the aperture located next to the inclined tank.

5. Before falling to the cab, confirmed whether or not left around the engine, especially around the exhaust pipe.

6. Pull the safety pin from the hole next to the tilt trailer and put it in the above holes.

1, 线 2, safe pin 3, plug

7. Pull up the tip stop lever and hold the wing of the cab to reduce the cab.

8. After the cab is completely released, press the tip lock rod.

9. Insert the lock pin into the hole on the tip.

warn:

1. When pulling the tip stop, do not fall below the cab, because the cab may drop due to its own weight.

2. Be sure to insert the lock pin into the hole of the tip rod to prevent the cabs from tilting in the drive.

This article reprints from the following products: Dongfeng car - \\\"Dongfeng EQ2102 / 2102G series Vietnam Motor User Manual \\\"