Views: 3 Author: Site Editor Publish Time: 2021-09-30 Origin: Site
Section 8 winch
First, the use of the winch
Put the clutch pedal, place the transmission lever in a neutral position, such as traction other vehicles, should brake the car hand brake, if necessary, hold the wheel
Clutch sleeve engaged in a winged drum
Start engine
Intensive reverse
Loosen the clutch pedal, and the drum is separated. The steel rope is released at this time while pulling the steel rope out of the trag. (The steel rope can be pulled out by hand without load, and the gear is not engaged)
Place the striker joystick in the middle (neutral) position.
Stepping on the clutch pedal, geometric force before the force.
Loosen the clutch pedal and simultaneously stepping on the throttle, so that the engine speed is within 1,000 to 1200 rpm, and the winding steel rope begins to pull.
After the traction is completed, the clutch pedal must be depressed, put the striker joystick in the middle position, and lock it with the lock plate to prevent the vehicle to drive automatically engage the gear.
Second, strictly prohibit the following operations
Ropeless car without combining a winch mechanism
The reverse gear of the car when the winch is working
When working on the winch, stand next to the steel rope or between the steel rope to finish the winding of the steel rope
Instead of insurance in bolts or other parts
The striker gear joystick is locked in the middle (neutral) position without locking.
This article is reproduced from: Dongfeng Truck Company Heavy Car Factory - Military Dongfeng off-road vehicle Adjustment and Maintenance Manual
