Views: 1 Author: Site Editor Publish Time: 2022-01-10 Origin: Site
Twenty six, the cab lights are not bright.
Cause Analysis:
1, left, right door light switch line does not light;
2, left, right gate lights open;
3. The right side width and top luminaire on the right side of the cab are unfair.
Method of exclusion:
1. First check if the right wire harness and the top beam plug in front of the cab is poor.
2. Check if the right gate of the right door is connected;
3. Check if the cab is left, if it is damaged, the right door light is also very bad or damaged.
EQ2102 is actively displayed
Twenty-seven, the cab is open, the two gears are not bright.
Cause Analysis:
1, the top light switch contact;
2, the top lamp seat is poor;
3. Drop the front of the taxi;
4, the top light switch is dead
Method of exclusion:
1. Check whether the right Qianssea in front of the cab is dropped;
2. Check if the vertical screw of the top base is installed;
3. Check the contact situation on the top light switch and whether the switch is Cardd.
EQ2102G chassis display
Twenty eight, the driver's top light, the second file is not bright
Cause Analysis:
1. Adverse contact between the filament is disconnected or the fuse box;
2, the top bulb is broken.
Method of exclusion:
1. Measuring whether the top luminaire on the right side of the cab is electrically, if there is no power, the filament is not in contact;
2, check if the ceiling is charred.
EQ2102G Axle
Twenty-nine, the steering signal light and the alarm light is not bright
Cause Analysis:
1. Adverse contact between the filament is disconnected or the fuse box;
2, the flash memory relay is broken;
3, the alarm flash memory relay is not good;
4, turn the light to open the crowd or the difference line harness contact;
5. Alarm light is closed or internally contact.
Tianjin EQ2102
Method of exclusion:
1. Check the contact box of the connector of the fuse box cable connector;
2. Check if the steering flash relay is damaged, check whether the two lines on the flash relay should have electricity, if one is no electricity, indicating the damage and replacement of the relay;
3. Check if the alert flash relay is damaged, the inspection method is the same;
4. If the flash relay is not faulty, check whether the working conditions of the turret switch and the alarm switch are good;
5. Check whether the contact of the wire beam connector is good.
This article reprints from the following: Dongfeng Truck Heavy Car Factory - \\\ Military Dongfeng off-road vehicle Adjustment and Maintenance Manual