Dongfeng EQ2063EYY6J Warrior The civilian version is a reliable, adaptability and strong modification Four wheel drive off -road truck chassis.
As the largest auto production
Brake system failure and exclude braking failure continuously step down on the brake pedal, the pedal does not rise, but also feels no resistance, first check if the master cylinder is lack, then check the master cylinder and the execution pump, there is no leak, if Leakage should be replaced; then check that the brake pipe and joints have no oil, if there is oil spill, it should be repaired or replaced; if no oil should check, there is no disengagement of each mechanical connection. If the above situation is good, the state of the inspection of the master cylinder kitbow and the piston should be decomposed, and it is necessary to repair or replace if necessary. Brakes 1. When the brake pedal is stepped on, the position is very low, and the pedal gradually increases, but it is weak, and the braking effect is not good. This shows that there is air in the brake system, excluded; 2. When the pin is braked, when the brake pedal is continuously stepped, the pedal position gradually increases, and the braking effect is better. This shows that the pedal free trip is too large, and the friction plate and the brake disc gap are too large or friction.
Splitter system failure and exclude 6.6.1 Internal Torque Load Blocking 1. Full parking, shift to the neutral file, then change to high-lock (H), when the high-lock file is not changed (H), does not make the vehicle Hard road surface; 2. The work oil used is incorrect or the work oil is insufficient, and the corresponding replacement is performed, added; If you enter (HL) gear, you should check the relevant technical unit repair vehicles in time. 6.7 Main Drive Faults and Excluding 6.7.1 Main Device Gear Meshing Is No Abnormal Nacerd 1. When the car starts, \"\ \" sound, when the car drives the instant or drag of the car, and the speed When the relative stability, the sound is reduced or disappeared, and it is confirmed by the exclusion of the transmission shaft, which is confirmed, which is too large, and can be adjusted by reducing the adjustment gasket; 2. If Axle send
After the transmission shift is difficult to eliminate the clutch fault factor, the analysis process is performed as follows: cannot be hosted, it may be lost, and the linkage parts are loosened, and the repair adjustment should be checked one by one; But more difficult, may be the fork axis deformation or rust post, which should be removed to check the movement of the fork axis, if there is a card to repair or replace; Whether the shaft hole is contained, whether the interlock spring is too large, otherwise it should be re-adjusted or processed; while the hook of the gear is difficult, the joker of the gear is damaged, and it is damaged. Fork bending deformation, synchronizer cone wear, guide bearing wear, etc. The transmission abaring vehicle When the reverse gear is started, the transmission sometimes generates \"
