Views: 3 Author: Site Editor Publish Time: 2021-08-14 Origin: Site
Light adjustment method
General adjustment
Park the car on the dark, flat road, turn the light switch in the near light, to turn the adjustment screw of the outer headlight, and adjust the low-light light. After adjustment, turn the light switch in the remote light, block the adjusted headlight with the cardboard, and turn the adjustment screw of the inside auxiliary headlight, adjust the high beam light.
Standard adjustment method
Ready to work
The light adjustment site requires flatness, and the screen used is vertical.
Vehicle is empty, take a driver, tyre The air pressure is normal.
The vehicle is perpendicular to the screen, allowing the headlights to center the screen 10M.
A horizontal basis is drawn on the screen, the height of the reference line is the same as the center of the front light, the height word is h, and the left and right headlight reference center position is marked according to the front light position of the vehicle in the horizontal basis. String.
Adjust the low beam first, then adjust the highlight.
Low beam lights
Light light beams on the screen, require:
The height of the light beam bright and dark line angle or midpoint is 0.6h to 0.8 h. 2. The horizontal direction should not exceed 100 mm.
High beam
High beam light beams on the screen, require:
The height of the beam center is 0.85H ~ 0.9H,
The horizontal position of the left side is not greater than 100m to the left side, and the right is not more than 170 mm.
The horizontal position of the right high beam is not greater than 170 mm.
Front fog lights
The front fog light distribution performance should produce a width of less than 2250 mm clear horizontal bright and dark lines on the 24m front fog base center. (The horizontal and vertical reference lines on the screen are the same as the steps in the preparation work).
This article is reproduced from: Dongfeng Motor Company - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"
