Steering System Power Steering System A) Double Bar Tree Steering Path: The outer diameter Ø480mm, the steering transmission is composed of a steering column and a steering drive shaft with two cross shafts universal joints. The steering drive shaft is divided into two parts: spline shaft and spline set. It can slide relatively. b) steering machine; integral power steering machine. The intermediate position transmission ratio is 20.4, c) The trapezoidal mechanism rear behind the front axle. Front wheel 主 主 主 定 定 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 轮 3 轮 轮 3 轮 轮 3 轮 轮
Basic parameters
The light adjustment method Generally adjusts the car parked on the dark, flat road, turn the light switch at the near-light, and the adjustment screws of the outer headlight, adjust the low-light light. After adjustment, turn the light switch in the remote light, block the adjusted headlight with the cardboard, and turn the adjustment screw of the inside auxiliary headlight, adjust the high beam light. Standard adjustment method Prepare the work light adjustment site requires flatness, and the screen used is vertical. Vehicle is empty, take a driver, tyre The air pressure is normal. The vehicle is perpendicular to the screen, allowing the headlights to center the screen 10M. A horizontal basis is drawn on the screen, the height of the reference line is the same as the center of the front light, the height word is h, and the left and right headlight reference center position is marked according to the front light position of the vehicle in the horizontal basis. String. Adjust the low beam first, then adjust the highlight. Lights Light Light Light Bunch on the screen, requires: beam bright dark line angle or medium
Auxiliary power starts are difficult to start due to battery powerless, engine starts, in order to start the vehicle available auxiliary power start. Connection program: 1. The engine is flameout with a good battery vehicle. 2. One end of the stretcher cable (red) is connected to the uncapable battery positive electrode terminal, and the other H-NO5-118 is connected to the positive electrode wiring 1 having the electric storage battery, and there is a battery column. Another end of another staller cable (black 2, no electric storage) is connected to the negative electrode 3 of a good battery, and the other end is connected to the vehicle chassis frame equipped with an electric storage battery, and must be allowed to stay away from the battery. . 3. After the stiffenser cable is connected, the vehicle engine without the electric storage battery is started. When the temperature is too low, the engine of the normal vehicle is operated by minutes, and the engine of the actuator vehicle is then started. 4. After the engine is started, the cable is removed in the reverse cable. Check tyre Air pressure and tread 1. Pressure table
Check the brake pedal stroke to clear the brake pedal, check its free trip, the normal value is 12 ~ 18mm. The brake pedal should not be bleed. There should be exhaust sound when the pedal is relaxed. Adjusting the front wheel of the front wheel per 12,000km adjustment should be checked. The recommended value of the front wheel of this car is 2 ~ 5mm. The adjustment method of the front wheel beam is adjusted to adjust the front wheel, and the car should be parked on the horizontal site, jack the front bridge, so that the wheel is in linear driving position, remove the horizontal puller, release the horizontal lever joint Tight bolts, rotate the national head, adjust the horizontal pulley length, so that the front beam value required for the car row. When adjusting, you can make a \"+ \" word mark in the middle of the tread pattern of left and right tyre, in the front bridge square, then turn the marker to the positive number to measure the B value, then turn the mark to the front The a value is measured, the front lead is the difference between A and B. After adjusting, tighten the bolts on the clamp. After collecting water, it will