Views: 2 Author: Site Editor Publish Time: 2021-08-12 Origin: Site
Brake pedal trip
Deep brake pedal, check its free trip, normal value of 12 ~ 18mm.
The brake pedal should not be bleed.
There should be exhaust sound when the pedal is relaxed.
Adjustment of front wheel head
The front wheel beam should be adjusted when maintained every 12,000 km. The recommended value of the front wheel of this car is 2 ~ 5mm.
Adjustment method for front wheel
When adjusting the front wheel lead, the car should be parked on the horizontal venue, jack the front bridge, so that the wheel is in a straight line. Remove the horizontal pulley, loosen the lever joint clamp lock bolt, turn the cross lever joint, adjust the horizontal pulley length, so that the front beam value required for the car row.
When adjusting, you can make a \"+ \" word mark in the middle of the tread pattern of left and right tyre, in the front bridge square, then turn the marker to the positive number to measure the B value, then turn the mark to the front The a value is measured, the front lead is the difference between A and B. After adjusting, tighten the bolts on the clamp.
Gasket
Gas drums must be made after the daily cars. Pull the water drum under the gas tube to put water.
This article is reproduced from: Dongfeng Motor Company - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"