Views: 4 Author: Site Editor Publish Time: 2021-08-05 Origin: Site
Splitter operation method
There are three gears on the mandatory switch. In general, the mandatory switch should be in the location of \"high \", when a larger traction is required, the mount is lowered.
When the mandatory is hung by a high-end, you must pay attention to:
The shift should be carried out at the car parking, and the shift is not allowed during the driver.
After the clutch is stepped on, the splitter switch handle is rotated to the \"low \" position.
Before the low gear, you must engage the front bridge drive, in the middle, the rear axle parts are overloaded, if not picking the front bridge, the low-frame gear will not hang.
1, the mandatory is in low gear
2, the mandatory is in the idle
3, the mandatory is high-grade
Method of operation of striker
The striker is used to control the winch, which can be used to save or self-help. There are three gears on the switch of the striker.
Using the striker, the Gearbox should first be in the neutral position, and press the clutch when the engine is run, and then the power switch is operated.
1. Practice output, winch drum, hire wrap wire rope
2, idle
3, strike power, winch drum relax wire rope
When the front bridge, the mandarizer or power is operated, if the sensory operation does not work, first check if the front indicator lights up, if not lit, the description is not hanging into the working file, or is still in a neutral. This generally has the following reasons:
1. Since the gear position is not suitable, you can't hang in once, at this time, you can move the car forward or later.
2. The long-distance control switch is not open.
3. The air pressure is too low, the cylinder pusher is not in place, and the pipe should be picked up until the pneumatic table pointer is over 600kPa, and then rediscar.
Driving instructions
The correct driving method can not only extend the life of the vehicle, but also improve economic benefits, and the impact on the safety vehicle is also great.
The following provisions should be observed when driving:
1. When the engine is the colder start, there should be a heater process before the vehicle starts. After the cold machine is started, the engine speed is slowly improved, so that the oil pressure, the engine combustion has stabilized with the heating of the engine. The engine is running until the exhaust color becomes light blue.
2. Do not increase the engine speed too quickly. The coolant temperature is low when the speed is rapidly increased to damage the engine. When the external temperature is below 0 ° C, the engine should be run for 5 minutes before the full load.
3. The throttle must be avoided and suddenly brake parking. The throttle is fully starting to cause clutch damage or uneven tyre wear; sudden brakes accelerate tyre and the wear of brake grinding sheets.
4. In 15 seconds after the start, pay attention to the changes in oil pressure.
5. After the engine's large load is running for a long time, it must be idling 3 to 5 minutes before the stop.
6. Before driving is not reached 4,000km, the engine speed should not exceed 2,800R / min.
7. It is strictly forbidden to use \"Accelerated an off-flameout one empty gear \" method.
8. It is strictly forbidden to overload the vehicle, and the overload will shorten the service life of the vehicle.
9. Establishment of lubricants and diesel must be employed according to the local use ambient temperature.
This article is reproduced from: Dongfeng Automotive - \"Dongfeng EQ2102 / EQ2102G Series Off-road Motor User Manual\"
