Maintenance and adjustment In order to extend the service life of the car, ensure safety and pleasant driving, must be fine to regular maintenance, this manual introduces some common maintenance and adjustment methods, more detailed inspection and adjustment, replacement, please close Contact Dongfeng Automotive Technology Service Center (station). Air filter maintenance filter inspection and cleaning cycle 8,000 km (dust regions 4, 000km) or air filter blocking alarm light is on. Generally only cleaned the outer filter, but when the alarm light is still on, the internal filter element is required. After 24,000 km of replacement cycle, the inside and external filter must be replaced at the same time. EQ2102 Air filter Replace Air filter filter 1. Loosen the butterfly nut cover of the filter ends and take the lower cover. 2. Remove the filter fastening nut and remove the filter. 3. Use the opposite procedure to install the components. Clearness of the filter
Splitter operation method
Take the non-car brake handle to the \"brake \" position, and hide the wheels with a wooden block. The status of the parcel is down, and the stroke switch is turned to the \"counter\" position. It is slow to loosen the clutch pedal, while balanced, the mountain, you can collect the wire rope, start to pull. After the introduction, the clutch pedal will be stepped on. The switch is in the idle, the drum clutch sleeve H-B-062 is in the \"separation \" position. 1. Release the brake 2, the brake position 3, pull up the virtue: 1, such as the winch has been used for a long time, then check the lubricating oil surface of the winch reducer before use, it should be added to use. There should also be a slap in which there is a stone between the winch drive shaft and the frame, so as not to damage the drive shaft and the power strip. The wire rope should be entangled before the winch is used. Generally, the wire rope should be immediately wrapped immediately to prepare for the next use. The wire rope is wrapped out, which will cause the upper steel wire rope to enter the next layer, resulting in a steel wire.
The car connection operation EQ2102, the EQ2102G trailer brake connection device is mounted on the rear beam of the frame, and its arrangement is shown in the visual -a-050. Dual Pipe Inflatable Making (Control Connector) Dual Pipes Inflatable (Supply Solver Connector) Single Turbine Offset System (Fault System Switch) 12V Seven-Hole Socket 24V Seven Hole Socket 1, Trailer Connection Operation Should be carried out in the flat, turn the hand-controlled valve to the locked position, the spring brake gas chamber is open in the normal state position (see page 22) and plug the wheel with a triangle pad. 2. Adjust the height of the traction ring of the trailer and the height of the traction hook. 3, connect the traction hook and the traction ring. 4. Connect the cable connector of the trailer with the tractor socket. 5. Connect the span hose joint to the output joint of the tractor. Note: 1. Hose joints cannot be received. 2. When connecting to the vintage artillery (single loop-off braking), please use the attachment of the car.
Blowing box 8, horn 9, brake lamp 10, front air defense lamp 11, rear air defense lamp 12, hazardous alarm 13, cab head lamp 14, steering signal light 1, engine start 2, engine intake preheating 3, instrument panel 4, engine extinguishing switch 5, cab warm air 6, windshield scrubber 7, work light socket 15, parking light 16, fog lamp 17, rear light 18, headlight (right high light) 19, large Light (right light) 20, headlight (left remote) 21, the adjustment of the headlight (left Light) steering wheel raised the steering wheel lock rod up, the steering wheel can perform front and rear tip adjustment and up and down axial direction adjust. After adjusting the direction of the steering wheel to the comfortable position, then the lock rod is downward and lock the steering column. Note: It is strictly forbidden to adjust the position of the steering wheel during the vehicle driving. 1, steering wheel lock stop
