Views: 9 Author: Site Editor Publish Time: 2021-08-04 Origin: Site
Traction
1. Put the parking brake handle to the \"brake \" position, and hide the wheels with a wooden block.
2. Put the clutch pedal and turn the stroke switch to the \"counter\" position.
3. Slowly release the clutch pedal, and balance the oil, you can collect the steel wire rope to start traction.
4. After the traction is finished, the clutch pedal is depressed, so that the striker switch is in the idler, the drum is located in the \"separation \" position.
1, release brake 2, brake position 3, pull up
Note:
1. If the winch has not been used for a long time, you should check the lubricating oil surface of the winch gearizer before use, and it should be added after it is insufficient. There should also be a slap in which there is a stone between the winch drive shaft and the frame, so as not to damage the drive shaft and the power strip.
2. Winged wire rope should be entangled. Generally, the wire rope should be immediately wrapped immediately to prepare for the next use. The wire rope is not tested, and the upper wire rope will enter the next layer, causing the wire rope to be discharged and easily damaged.
3. The length of the wire rope should not exceed 54 meters, and the remaining wire rope wrapped around the drum should not be less than 5 laps.
4. Prohibition of continuous use of a winch for a long time, such as a long time of use, pay attention to the temperature of the reducer, not hot, such as the purity of hair, and keep it after the cooling.
5. When the wire rope must be pulled with manpower, otherwise, the wire rope on the drum will automatically loose in the reverse direction, so that the upper wire rope is subjected to the next layer, and the card is broken. The maximum traction of the winch is 4,500kg, which is not allowed to be used. If you need more traction, the pulley should be used.
6. Wire rope traction direction should be kept perpendicular to the flattening of the bumper, the traction direction is not more than 15 ° to the car center line, so as not to send and damage the guide rod.
Warning:
When the winch is used for the first time, the wire rope should be released (54M), and then tighten the wire rope in the case of load (4500 kg), and how much is needed in the future, this can reduce the wire rope during use. The upper steel wire rope will prevent the wire rope from being damaged prematurely.
2. Do not engage the winch and drag the car with a wire rope.
3. It is forbidden to work next to the wire rope when the winch is working.
4. Prohibit demolition of automatic brakes.
5. The maximum traction of the winch is 4500kg, such as the load is too large, may cut the safety pin of the drive shaft of the stripper to avoid damage to the winch.
6. Prohibit the instead of the security sales in bolts or other parts.
Safe pin
Base
The pulley is used to increase the traction of the winch and change the traction direction.
1. Use the pulley to change the traction direction.
2. When the angle of the car center and the traction direction exceeds 15 °, it is necessary to change the traction direction in the traction direction.
3. When the mutual rescue needs to increase traction, the pulley must be fixed to the front tow hook being saved.
1, fixed pillar 2, puller
This article is reproduced from: Dongfeng Motor Company - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"
