Checking with the addition of the coolant coolant to cool down heat dissipation, anti-rust freezing, so it must ensure that the vehicle must be sufficient in the water tank during the driving process, especially in winter. It is more important when harsh traffic is traveling. 1. To check the liquid plane of the coolant, the ignition key can be screwed to the ON position, check if the liquid surface alarm light of the coolant is lit, if the buzzer is turned out, the coolant is required. It can also be used directly from the expansion water tank to observe. If you do not see the water surface, you must add 2. If you add the coolant from the expansion water tank from the back of the cab, until the coolant page reaches 4/5 of the expansion tank height. 3 Check the sealing box of the injection pressure cover Note: 1. Before adding the coolant, you must check if the engine cartridge radiator is leaked. If there is a first repair 2. Coolant is recommended to use Dongfeng Motor company production Antifreeze anti-rust cooling
Intance preheating start operation
Take the non-car brake handle to the \"brake \" position, and hide the wheels with a wooden block. The status of the parcel is down, and the stroke switch is turned to the \"counter\" position. It is slow to loosen the clutch pedal, while balanced, the mountain, you can collect the wire rope, start to pull. After the introduction, the clutch pedal will be stepped on. The switch is in the idle, the drum clutch sleeve H-B-062 is in the \"separation \" position. 1. Release the brake 2, the brake position 3, pull up the virtue: 1, such as the winch has been used for a long time, then check the lubricating oil surface of the winch reducer before use, it should be added to use. There should also be a slap in which there is a stone between the winch drive shaft and the frame, so as not to damage the drive shaft and the power strip. The wire rope should be entangled before the winch is used. Generally, the wire rope should be immediately wrapped immediately to prepare for the next use. The wire rope is wrapped out, which will cause the upper steel wire rope to enter the next layer, resulting in a steel wire.
Special equipment winches and pulps (optional) winches and pulps will be saved, mutually rescued or other uses when necessary. A wire rope is discharged 1. Manrate the tube into the \"1 \" position, engage the tube. 2. Start the engine in the idle position. 3. Put the clutch pedal and turn the power switch to the position of \"positive \". 4. Slowly loosen the clutch pedal, and the wire rope can be released. If the striker switch is in the \"empty \" position, the drum is placed in the \"separation \" position, and the wire rope can also pull out. Note: HA-O62 1. Joint 0. Distribution Box Dunction Body Rehabilitation HA-0171, Practice Output, Winged Drum Slips Wound Wire Rope 2, Negota 3, Practice Output, Winged Drum Relaxation Wire Rope 1. Before use First check if the wire rope is intact, reliable, and strictly forbidden to use a broken wire rope. 2. The throttle is not available when discloses the wire rope
The car connection operation EQ2102, the EQ2102G trailer brake connection device is mounted on the rear beam of the frame, and its arrangement is shown in the visual -a-050. Dual Pipe Inflatable Making (Control Connector) Dual Pipes Inflatable (Supply Solver Connector) Single Turbine Offset System (Fault System Switch) 12V Seven-Hole Socket 24V Seven Hole Socket 1, Trailer Connection Operation Should be carried out in the flat, turn the hand-controlled valve to the locked position, the spring brake gas chamber is open in the normal state position (see page 22) and plug the wheel with a triangle pad. 2. Adjust the height of the traction ring of the trailer and the height of the traction hook. 3, connect the traction hook and the traction ring. 4. Connect the cable connector of the trailer with the tractor socket. 5. Connect the span hose joint to the output joint of the tractor. Note: 1. Hose joints cannot be received. 2. When connecting to the vintage artillery (single loop-off braking), please use the attachment of the car.
