Dongfeng EQ2102 Series Off-road Motor User Manual - Maintenance and Adjustment - Checking and Adding Coolant

Check and add coolant

1. To check the liquid plane of the coolant, the ignition key can be screwed to the ON position, check if the liquid surface alarm light of the coolant is lit, if the buzzer is turned out, the coolant is required. It is also possible to view the expansion tank to observe, if you don't see the water, you must add

2. Fill the coolant from the expansion tank from the rear of the cab, until the coolant page reaches 4/5 of the expansion tank height.

3. Check the sealing box working in the stuffed pressure cover

Notice:
1. Before adding a coolant, you must check if the engine cartridge radiator leaks, if necessary, repair
2. The coolant is recommended to use Dongfeng the best-selling antifreeze anti-rust coolant produced by the car company, which is strictly prohibited to use tap water or well, river hard water

Radiator drainage
The switch shown in the following figure opens the cooling solution in the cooling system.

Replace engine lubricating oil

Replacement cycle
For the first time: New model is 1500km
Replacement in the future: 8000km

Check engine lubricating oil plane
1. About 5 minutes after the engine is turned off, pull the oil ruler out, wipe it with a hurry to remove it and then reload the ruler
2. Pull the oil mark again and observe the height of the oil plane. There is a need to add a cleaning lubricating oil between the normal range. Excessive also removes from the oil spline. The rails of the oil ruler indicate both the existing capacity of 14.3L, and the bottom line indicates both capacity 12.4L.

Replace engine lubricating oil

1. Oil shell 2. Putting oil

1. Seal the oil bottom of the oil in the bottom of the oil, pick up the oil, put the lubricating oil in the oil housing.

2. Re-decorate the oil drill

3. Replace the oil filter, and clean the filter seat oil seal joint surface

4. Add new lubricants as required

5. Start the engine, in the case of idle speed, observe the filter and the oil absorbing screw without leakage. After the stop is waiting for 5 to 10 minutes, the oil level of the engine lubricating oil is verified until the lubricating oil level is a normal range.

   
   

   
   

1. Crease hole

This article is reproduced from: Dongfeng Motor Company - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"