Dongfeng EQ2102 Series Off-road Motor User Manual - Starting and Driving - Impighter Preheating Start Operation

Intake preheatingstartoperate

The intake preheating is provided to facilitate the start of the engine at a low temperature environment (5 ° C to -41 ° C).

The steps are as follows;

1. Closed intake preheating switch.

2. Pull out the preheating wind door button, the intake preheating indicator is on, and the preheating begins. When using the intake, the air doors are pulled out, directly pull the pull button to a suitable position, and the intake preheating damper button will remain in this position.

1, warm-up wind door button 2, intake preheating switch

3. The preheating time is 6 minutes. After the preheating is over, the intake preheating indicator flashes, the buzzer is called, and the engine can be started.

4. After the start is successful, the preheating start switch should be turned off, reset the preheating wind door button, press the button to press the drop button head, and then push the boot button.

If the start is unsuccessful, the above steps can be repeated.

The preheater is 12 minutes. The preheater is automatically cut off when the preheated time ends the engine is not started or after starting the preheater for 12 minutes. The buzzer stops twisting, the indicator is turned to a frequently lit, indicating that the driver should turn off the preheater switch.

Note:

1. In the normal operation of the preheater, if the engine is unsuccessful, the engine start speed and the fuel supply condition should be checked.

2. When using a preheater in a very low temperature environment, it is not necessary to prevent the throttle pedal to the end to prevent rapid rapid increase in the start of the engine.

3. When the vehicle is insufficient, the battery should be used with caution using the intake preheater according to the battery capacity.

Hold-round library

When the vehicle is used in a cold environment of -41 to -30 ° C, refer to the following use points:

1. The fuel is selected from -50 diesel.

2. Engine lubricants use OW / 30 CD diesel oil, temporarily use the 14th severe cold area thicker oil instead of

3. Use long-acting antifreeze.

4. Use a low temperature battery and a battery thermal insulation device.

5. Use a cylinder coolant heater and an electric electric heater to heat the cylinder and the oil bottom shell.

EQ2102 Series models can optionally cooled coolant heaters, engine oil electric heaters and engine preheating wires, as long as there is AC power supply in the parking place.

When using a heater, a preheated wire beam (two) is interposed on the cylinder coolant heater and the oil electrical heater, and the other is inserted on the 220V AC socket (see Figure H-A-061).

The engine cylinder coolant heater and the motor oil electric heater are used, and the working temperature is more than 106 ° C, and the engine can start smoothly.

1, electrical electric heater 2, connected 220V AC power

This article is reproduced from: Dongfeng Automobile Company \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"