Splitter system failure and exclude 6.6.1 Internal Torque Load Blocking 1. Full parking, shift to the neutral file, then change to high-lock (H), when the high-lock file is not changed (H), does not make the vehicle Hard road surface; 2. The work oil used is incorrect or the work oil is insufficient, and the corresponding replacement is performed, added; If you enter (HL) gear, you should check the relevant technical unit repair vehicles in time. 6.7 Main Drive Faults and Excluding 6.7.1 Main Device Gear Meshing Is No Abnormal Nacerd 1. When the car starts, \"\ \" sound, when the car drives the instant or drag of the car, and the speed When the relative stability, the sound is reduced or disappeared, and it is confirmed by the exclusion of the transmission shaft, which is confirmed, which is too large, and can be adjusted by reducing the adjustment gasket; 2. If Axle send
After the transmission shift is difficult to eliminate the clutch fault factor, the analysis process is performed as follows: cannot be hosted, it may be lost, and the linkage parts are loosened, and the repair adjustment should be checked one by one; But more difficult, may be the fork axis deformation or rust post, which should be removed to check the movement of the fork axis, if there is a card to repair or replace; Whether the shaft hole is contained, whether the interlock spring is too large, otherwise it should be re-adjusted or processed; while the hook of the gear is difficult, the joker of the gear is damaged, and it is damaged. Fork bending deformation, synchronizer cone wear, guide bearing wear, etc. The transmission abaring vehicle When the reverse gear is started, the transmission sometimes generates \"
After the vehicle is turned off, the start time is too long.
The engine fan is so good to hear an abnum in the car, first should be turned off to avoid the heat sink due to fan blade break; use the starter to drive the fan low speed rotation, see if there is no operation interference or before and after swinging; stop The engine rotates, and the fan blades are pulled out by hand. If there is any explanation of the fastening bolt of the fan leather wheel or fan should be fastened; when the root of the fan is found, it should be replaced in time; during driving; When the fan blade is broken, the symmetrical blade can be removed, and the engine speed cannot be too high. Water temperature is low and water tank \"Water \" water temperature is not high, the coolant in the expansion tank or heat sink drapes, water vapor spills; elevated speed, \"Water \" phenomenon, different from \" \"Phenomenon; the coolant is reduced;\" \"Water \" is serious, there is water to enter the cylinder, exhaust the exhaust pipe to discharge white smoke;
Engine system failure and exclude fuel filter air leakage, oil leakage, blockage, damage 1. Open the fuel prefilter discharge valve to discharge water and precipitate; 2. Replace the filter and oil separator. 6.2.2 Oil Road blocking, fuel tank pipeline icing, the filter element is too dirty oil supply 1. Whether the oil path low-pressure oil pipe is removed from the previous order, and the method of blowing is observed whether the oil pipe is smooth, if there is Substitute or icing is timely excluded; 2. If the filter is too dirty, the filter element is replaced. 6.2.3 Engine fuel injection pumps No oil 1. The oil pump does not pump. Check the wear situation of the components of the oil pump, the pipeline blocking condition, the air leakage of the deflation screw and the sealing property of the push rod and the housing; 2. The filter or pipeline may block, using high pressure gas to open the line; 3 The sealing property may not be good, check the oil tank to the oil pump and the oil supply pump to the sealing of the injection pump line; if it is a fuel injection pump, it is repaired to the designated service station. 6.