Views: 2 Author: Site Editor Publish Time: 2021-08-12 Origin: Site
tyre inflatable device
The gas barrel is equipped with an air valve, tyre Inflatable steps are:
Drease the butterfly nut, screw the butterfly nut of the inflatable hose into the pneumatic valve interface, you can inflate the tyre;
Start the engine to start the air compressor. In the inflation process, keep the engine rotate at 1000R / min;
When the tyre The air pressure reaches the specified value, remove the inflatable hose, screw the pneumatic valve butterfly nut, and stop the engine operation.
1, air supply valve
Winch maintenance (optional)
The winch should be regularly maintained according to the frequency of use, often check the fastening bolts throughout the tightening bolts, regularly check the lubricating oil surface of the speed reducer, and add, if there is oil spill, it should be eliminated in time, lubricating oil over dirty Replace, regularly clean the cross shaft and spline of the sliding winch drive shaft.
12,000 kilometers should be taken to the bearing of the bearing, and the guide wire bar bearing is added to the lens. The transmission chain, the guide screw and the slider should often apply grease or a grease or anti-rust oil on the steel rope.
If it is found that the gearizer does not have a short heat or abnormal sound, it should be checked to tighten the fastening bolts of each bearing cover. If it is still not eliminated, the repair department should be sent to repair.
1, reducer oil surface inspection hole screw 2, oil absorber
This article is reproduced from: Dongfeng Motor Company - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"
