Section III EQ2102 off-road vehicle engine: 6BT5.9, six-cylinder, water-cooled four stroke, exhaust gas turbine boost diesel engine cylinder stop X stroke 102x120 mm displacement 5.88L Rated power (2800R / min 118kw MAX. torque (1600R / min) 546N-M minimum fuel consumption ratio (1200 ~ 1700R / min) 224 (g / kW-h) compression ratio 17.5 clutch: single-chip dry film spring clutch, subgrade Vibration spring and friction damping tablets, frictional outer diameter 4) 350 mm, hydraulic long-distance manipulation, booster, hanging pedal. Gearbox: Mechanical transmission type transmission. Five forward gear and a reverse, two to five gear synchronizers, with an oblique toothed gear. Center distance: 135mm. Each speed ratio is: '= 6.602 i2 = 3.7
Bulb Replacement Replacement Complex Light Bulb 1, Steering Lamp 2, Front Lamp Replacement Light Bulb Replacement Fog Light Bulb Replacement Side Steering Light Bulb Replace Air Defense Light Bulb Replacement Blank Light Bulb Replacement Combined Light and Removal Light Bulb 1 , 2, 3, 4,
Check and replace the power steering hydraulic oil before the oil plane is checked, the oil tank is clean. Remove the fueling cover with oil rod assembly, wipe the ruler, reload the oil ruler, then take the oil standard, observe the height of the oil plane. If the oil plane is not on the bottom of the oil roll, it is necessary to add the same type of hydraulic oil inspection cycle for the first 4000km replacement cycle for the first time, 4000km per drive 24000km replacement method 1. Put the car's rear wheels with triangle pads , The transmission is set, and the front axis is jealous with jack, so that the two sides tyre are separated from the ground 2. Remove the steering and extracting the tubing, all discharge the oil fluid of the steering system. At the same time, start the engine, reverse the steering wheel 3. After confirming that the system oil discharges clean, open the storage tank cover, replace the hydraulic oil filter 4. After the filter is replaced, the oil tank is added, and the engine will start the engine. The engine is idling, after the flameout
Maintenance and adjustment In order to extend the service life of the car, ensure safety and pleasant driving, must be fine to regular maintenance, this manual introduces some common maintenance and adjustment methods, more detailed inspection and adjustment, replacement, please close Contact Dongfeng Automotive Technology Service Center (station). Air filter maintenance filter inspection and cleaning cycle 8,000 km (dust regions 4, 000km) or air filter blocking alarm light is on. Generally only cleaned the outer filter, but when the alarm light is still on, the internal filter element is required. After 24,000 km of replacement cycle, the inside and external filter must be replaced at the same time. EQ2102 Air filter Replace Air filter filter 1. Loosen the butterfly nut cover of the filter ends and take the lower cover. 2. Remove the filter fastening nut and remove the filter. 3. Use the opposite procedure to install the components. Clearness of the filter
