Views: 62 Author: Site Editor Publish Time: 2021-08-04 Origin: Site
New car
The access mileage of the new car is set to 1,000 ~ 2,500km, and the new car is only passed from normal use after driving 2,500km. The new car has passed the strict running period, and the vehicle allocute pair and each unit have reached the most I, the performance of the vehicle can be effectively played. Otherwise, it will be due to insufficient power, and it is too early to load I Sichuan. The initial excessive wear of the part.
The following provisions should be observed within the joint period of the new car:
Before walking
1. Clean the car, check the connection and fastening of each part.
2. Check the amount of cooled liquid deposits and inspect the phenomenon of no leakage in the cooling system.
3. Check the engine, clutch manipulation system, transmission, splitter, drive bridge, balance the oil surface of the bearing hub, the scooter and the steering machine, and is added, and there is no oilproof phenomenon in each portion.
4. Check that all parts of the steering mechanism have no loosening and issuance.
5. Check that the work of the brake system is normal, and there is no leakage phenomenon at each pipe joint.
6. Check whether the work of the electrical equipment, the lights and the instrument is normal, and check the battery electro-liquid surface.
7. Check if the air pressure meets the standard.
8. Check the transmission, the unit files can be joined correctly.
Ahead
1. Should be driven on a flat road.
2. Correct driving, smoothly engage the clutch, shift in time, strictly prohibit hard support, fierce, avoid sudden acceleration and dramatically braking.
3. Frequently paying attention to the temperature of the transmission, mandatory, drive bridge, hub and brake drum, if there is severe fever, you should find out if it is adjusted or repaired.
4. Pay special attention to the temperature of the oil pressure and engine coolant;
5. It is strictly forbidden to load within 250km starting, and the engine speed is strictly forbidden to exceed 2000R / min.
6. During the 250km walk, the vehicle load is strictly forbidden to exceed 75% of the load weight, and the engine speed cannot exceed 2000r / min.
7. The proportion of ratios using the front bridge should be not less than 1/3 of the mileage during the journey.
The new car should pay attention to:
After the engine is started, it is preheated in an appropriate light load or no-load operation.
The engine is strictly forbidden for a long time, and the idle speed cannot exceed 5 minutes.
Avoid running for a long time.
Reasonably use the shift gear, avoid the engine overload.
Always pay attention to the oil pressure and temperature indication of the engine.
The engine lubricating oil surface and the coolant surface should be checked frequently.
Correct driving, avoid emergency braking.
Warning:
It is strictly forbidden to hang the empty gear slide.
Take care of maintenance
After you are finished, be sure to go to the local Dongfeng Automotive Technical Service Station to take care of the maintenance, the maintenance content and project table see the relevant chapters of this book.
Vehicle use
Engine start
1. Please perform daily check.
2. Verify that the transmission shift joystick is in the neutral position.
3. Step the accelerator pedal to the medium speed position, the clutch pedal step, and turn the key to \"START position, start the engine.
4. After the engine starts, relax immediately, slowly relax the pedal, transition to idle operation position, and be sure to observe the oil pressure in 15 seconds.
5. When a cold start engine, step on the accelerator pedal first, and release the accelerator pedal before the starter is disengaged.
6. Operate the engine for 3 to 5 minutes before the load run.
Note:
Each start engine time is not allowed for more than 30 seconds. At least 2 minutes at least 2 minutes per two boots.
To ensure safety, you must step on the clutch pedal when starting the engine.
This article is reproduced from: Dongfeng Motor Company - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"
