Dongfeng EQ2102 Series Off-road Motor User Manual - Maintenance and Adjustment - Check and Replace Speed ​​Oil

Check with replacement transmission oil

inspection cycle

Row 4,000km

Inspection Method

Unscrew the fuel and oil surface inspection hole sealing screw in the oil surface, and the height of the oil surface is subject to the lower edge of the screw hole, and it is not enough. At the same time, it should also be checked and cleaned.

1. Cooking and oil surface inspection hole 2. Put the oil rush

Replacement cycle

Each 24,000km maintenance

Replacement method

The transmission lubricating oil should be replaced in the hot car state. When replacing, the oil dried screw is screwed, and the oil in the transmission is discharged, and the oil and discharge screw (the magnets in the screw adsorbed the iron) of the oil in the oil) and removed, from the oil surface inspection hole Add new lubricants.

Notice

1. The oil surface is too low to burn bad bearings and gears, which will cause overheating and oil leakage.

2. The ventilation sessher should always be maintained.

Check with replacement of differential oil

inspection cycle

Each driving 4,000km

Replacement cycle

24,000km

Examination of the bridge lubricating oil

inspection cycle

Each driving 4,000km

Replacement cycle

24,000km

Inspection Method

Unscrew the oil surface inspection hole screw, the height of the oil surface is subject to the lower edge of the inspection hole, and it is not enough. At the same time, check the condition of the air plug and clean it.

1, ventilator 2, fuel port screw 3, oil surface inspection hole screw 4, drain rush

Note:

1. Do not let the dust or dirt into the main orientation when refueling.

2. The oil surface will be used in normal height, too high or too much. 3. The ventilation sessher should always be maintained.