Dongfeng EQ2102 Series Off-road Motors Handbook - Starting and Driving - Clutch Operation

Clutch operation

When using a clutch, the separation must be thoroughly; the clutch separation is not completely a major cause of damage clutch. In the driving process, the shift method of the two leg clutch is recommended from the high-speed gear to the low-speed file shift or by the low speed to the high speed gear. Do not put your feet on the clutch pedal after completing the clutch operation

1. Quickly press the pedal 2. Transmission manipulation lever to air block 3. Fast release pedal 4. Quickly press the pedal 5. Shift 6. Quick clutch pedal to the semi-engagement position, and slowly relax the clutch pedal

Braking operation

To make the vehicle stop, the brake pedal should be operated as follows:

1. Before the parking place, 25 ~ 35m, the brake pedal is taken below 1/2 ~ 1/3;

2. When the parking place is scheduled 5 to 6m, the pedal is gradually relaxed;

3. Before you go to the parking place, gently step down to stop the car completely.

Note:

1. If the brake pedal is not placed, the car will stop in short-range impact.

2. Avoid breaking the brake pedal, as this may discharge the air in the gas tube, resulting in loss of the vehicle.

3. When braking for parking, a foot brake should be used.

4. In addition to emergency, emergency braking methods should not be used. Especially in the case where the rainy road is easy to slip, the use of emergency braking is very likely to happen.

5. After washing or passing through a deeper puddle, there may be water into the brake drum, so that the braking efficiency can be reduced, and step on a few feet brakes at a low speed, the water is evaporated to ensure that the brake can work properly.

Parking operation

1. Try to park in a flat place during the car.

2. The parking brake handle is switched to the brake position, and the transmission is sealed, and the wheel is plugged with a triangle pad.

3. Before parking, please do not immediately turn off, you must run 3 to 5 minutes in the idle state, and you can turn off the engine coolant temperature. Especially after the engine's large load or high speed, it must enter the idle speed, otherwise the occurrence of a fault such as an engine pull tach and a supercharger.

4. Turn off all switches after the flameout, especially the power switch.

Go back

1. The truck is on, and there is no oil and other anomalies.

2. Turn on the gas tube and release the water, exclude water.

3. Repair the failure found during the driving process.

This article is reproduced from: Dongfeng Motor Company - \"Dongfeng EQ2102 / 2102G Series Off-road Motor User Manual\"